NTP server Lantime m600

LANTIME/M600/GPS

NTP time server for 19" installation  with management CPU and internal time reference:
GPS satellite receiver/radio clock with OCXO-LQ Timebase *)
- Meinberg GPS antenna input,  BNC female connector, isolated

4 x LAN interface 10/100 MBit, RJ45 connector
1 x Terminal RS232 interface, 9pin D-Sub male connector
      for initial setup and configuration
1 x USB Service interface
1 x  Grafic VF-Display (256 x 64 dots) and 8 push buttons

Signal Outputs:
2 x RS232 interface, independent, 9pin D-Sub female connector,
      with multi data formats timestrings.
1 x PPS, TTL into 50 ohm, pulse duration 200 msec,
      active high, female BNC connector
1 x PPM, TTL into 50 ohm, pulse duration 200 msec,
      active high, female BNC connector
1 x Synthesizer for frequencies from 0,1 Hz up to 10 MHz,
      TTL into 50 ohm, female BNC connector
1 x Standard Frequency 10 MHz, TTL into 50 ohm, female BNC connector
1 x Time Code AM, amplitude modulated sinewave output (e.g. IRIG-B12x) ,
      3 Vpp into 50 ohm,  via female BNC connector 
1 x Time Code DCLS, Pulse-width modulated output (e.g. IRIG-B00x), 
      TTL active high, via female BNC connector 
      (AM and DCLS Time Code signals are generated in parallel )
      additionally Time Codes available: IEEE1344 und AFNOR NFS 87-500.
1 x Alarm Relay Output, change-over contact, 3pin DFK connector

Technical specifications:

Power supply: 100-240 V AC (50-60 Hz)
Power consumption: max. 30 W
19" metal chassis, 1 U/84 HP
(483 mm wide x 43 mm high x 285 mm deep)

Scope of Supply:
The system will be delivered inclusive of GPS/Converter
outdoor antenna, mounting kit and 20 m  coax-cable (RG58).