NTP Time server, Lantime M300/GPS

The Meinberg LANTIME M300 time server provides accurate time to networks of any size.

It synchronizes all NTP- or SNTP-compatible systems.
The M300 time server uses as a reference time source either any compatible external or built-in Meinberg reference clock (Stratum 1 mode) or up to 7 NTP servers (Stratum 2 mode).
 

• NTP time server for 19" installation with management CPU and internal time reference:
• GPS satellite receiver/radio clock with TCXO Timebase *)
• Meinberg GPS antenna input,  BNC female connector, isolated
• 2 x LAN interface 10/100 MBit, RJ45 connector
• 1 x Terminal RS232 interface, 9pin D-Sub male connector  for initial setup and configuration
• 1 x USB Service interface
• 1 x LC-Display (2 x 40 characters) and 8 push buttons
• 3 year waranty
• Free Unlimited support and firmware updates

----------------------------------------------------------------------------------------------

Signal Outputs:

• 2 x RS232 interface, independent, 9pin D-Sub female connector, with multi data formats timestrings.
• 1 x PPS, TTL into 50 ohm, pulse duration 200 msec, active high, female BNC connector
• 1 x Standard Frequency 10 MHz, TTL into 50 ohm, female BNC connector
• 1 x Alarm Relay Output, change-over contact, 3pin DFK connector

----------------------------------------------------------------------------------------------

Technical specifications:

• Power supply: 100-240 V AC (50-60 Hz)
• Power consumption: max. 30 W
• 19" metal chassis, 1 U/84 HP
• (483 mm wide x 43 mm high x 285 mm deep)

----------------------------------------------------------------------------------------------

Scope of supply:

The system will be delivered inclusive of GPS/Converter outdoor antenna, mounting kit and 20 m  coax-cable (RG58).